自上料攪拌車使用功能與進出料的事項
自上料攪拌車使用功能：
Function of self-feeding mixer:
自上料攪拌車應安裝在堅實平整的地面上，防止因地面下陷發生傾倒。
The self-feeding mixer shall be installed on a solid and flat ground to prevent tipping due to ground subsidence.
自上料攪拌車廠家建議，在使用作業前，應按清潔、緊固、潤滑、調整、防腐的程序檢查機器各系統，并使之符合要求；有事故隱患須及時。
The manufacturer of the self-feeding mixing truck suggested that before use, all systems of the machine should be checked according to the procedures of cleaning, fastening, lubrication, adjustment and corrosion prevention, and make them meet the requirements; Any potential accident must be eliminated in time.
電力驅動的自上料攪拌車，配電設備應安裝適當?shù)娜蹟嗥骷敖拥匮b置，以確保電氣系統的。
The power distribution equipment of electrically driven self-feeding mixer shall be installed with appropriate fuses and grounding devices to ensure the safety of the electrical system.
自上料攪拌車在運行中，勿使砂石落人機械的運轉部分中去，否則，零件易被卡住而損壞。
During the operation of the self-feeding mixer, do not let the sand and stone fall into the running part of the machine, otherwise, the parts will be easily blocked and damaged.
進料斗升起后，斗下不得有人通過或停留。
After the feed hopper is raised, no one shall pass or stay under the hopper.
自上料攪拌車進出料：
Feeding and discharging from the loading mixer:
出料前不能無故停車，亦不能加料后啟動。入料量不能超過規定容量。
Do not stop without reason before discharging or start after feeding. The feeding amount shall not exceed the specified capacity.
攪拌工作結束后，要及時清洗自上料攪拌車，防止混凝土結塊。清洗時，要防止電器設備受潮。清洗工作須在斷電后進行，以防止觸電。
After mixing, the self-feeding mixer truck shall be cleaned in time to prevent concrete caking. During cleaning, electrical equipment shall be protected from moisture. The cleaning work must be carried out after power failure to prevent electric shock.
每次充電前用水沖洗進料口，使進料口在充電時保持濕潤；
Flush the feed inlet with water before each charging to keep it moist during charging;
裝車的同時給隨車自帶的清洗水箱加水；
At the same time of loading, add water to the washing water tank provided with the vehicle;
自上料攪拌車裝料后沖洗進料口，清理進料口附近殘留的混凝土；
Flush the feed inlet after the loading of the loading mixer and clean the residual concrete near the feed inlet;
在施工現場卸料后，沖洗卸料槽，然后在混凝土儲槽中加入30-40L的清洗水；車輛返回時，保持混凝土儲罐向前緩慢轉動；
After unloading at the construction site, wash the unloading tank, and then add 30-40L of cleaning water into the concrete storage tank; When the vehicle returns, keep the concrete tank moving forward slowly;
下次裝車前切記將混凝土儲罐內的污水排出；
Remember to discharge the sewage in the concrete tank before the next loading;
每天結束時，清潔混凝土儲罐及進出口周圍。自上料攪拌車的清潔點確保沒有水泥和混凝土結塊。更多相關內容就來我們網站http://m.zvmc.cn咨詢吧！
At the end of each day, clean the concrete storage tank and around the inlet and outlet. The cleaning point of the self-feeding mixing truck shall ensure that there is no cement and concrete caking. Come to our website for more relevant content http://m.zvmc.cn Ask!
