駕駛自上料攪拌車要避免三個錯誤操作
自上料攪拌車成為各個建筑廠家所喜愛的一種攪拌車類型，但是它的工作并不僅僅局限于混凝土的攪拌工作，還包括混凝土的運輸工作，由于車輛的結構比較特殊，在駕駛的過程中是很容易發生一些危險事故的，所以下面跟著自上料攪拌車廠家看看下駕駛要避免三個錯誤操作是怎樣的。
The self loading mixer has become a favorite type of mixer for various building manufacturers, but its work is not limited to concrete mixing, but also includes concrete transportation. Due to the special structure of the vehicle, it is very easy to have some dangerous accidents during driving, so follow the self loading mixer manufacturer to see how to avoid three wrong operations when driving.
一、過度熱車
1、 Excessive hot car
不管是冬季還是其它季節，有很多車主都習慣采取原地怠速熱車的方式，熱車一段時間再行駛，覺得自上料攪拌車，這時性能佳。但事實上，原地怠速熱車不僅效果有限，還浪費汽油和時間。
No matter in winter or other seasons, many car owners are used to idling the hot car in situ. After driving the hot car for a while, they feel that the self feeding mixer has good performance. But in fact, the hot car idling in place not only has limited effect, but also wastes gasoline and time.
當引擎在沒有負荷的狀態下，溫度的爬升是相當緩慢的，也就是說，引擎在怠速狀態下需要很長的時間才能達到正常的工作溫度。
When the engine is under no load, the temperature climbs very slowly, that is to say, it takes a long time for the engine to reach its normal operating temperature at idle speed.
正確的做法應當是自上料攪拌車，原地?zé)彳?0秒左右后，立即上路行駛。但由于此時引擎及驅動系統都尚未達到正常的工作溫度，仍應將轉速控制在約2000轉/分鐘之內，待水溫達到正常后方可高轉速運行。
The correct way should be to start from the charging mixer truck, warm up the truck in situ for about 30 seconds, and then drive on the road immediately. However, since the engine and drive system have not reached the normal operating temperature at this time, the speed should still be controlled within about 2000 rpm, and the high speed operation can be started only after the water temperature reaches normal.
二、熄火后仍使用電器設備
2、 Use electrical equipment after flameout
一旦自上料攪拌車，熄火，蓄電池就處于只放電不充電的工作狀態。所以如果在長時間熄火后仍然一直在使用車內大功率用電器，比如開著車輛大燈、停車在路邊長時間聽音樂等等，這樣可能很快導致蓄電池放電、自上料攪拌車，無法啟動的嚴重后果。
Once the self loading mixer is turned off, the battery will be in the working state of only discharging but not charging. Therefore, if the high-power electrical appliances in the vehicle are still used after the ignition is stopped for a long time, such as turning on the headlights of the vehicle, parking at the roadside for a long time to listen to music, etc., this may soon lead to battery discharge, self loading mixer, and serious consequences of failure to start.
三、油箱見底后才加油
3、 Refuel after the fuel tank bottoms out
有人比較懶，有人是很少去注意油箱刻度，直到油箱警示燈亮起后還會再行駛一段距離再去加油?？墒怯袝r(shí)燃油警示燈亮起后再去找加油站時，有可能出現附近沒有加油站的情況，弄得手忙腳亂。而且經常出現這樣的情況的話，攪拌車的油泵壽命可能會大大降低。
Some people are lazy, and some people seldom pay attention to the fuel tank scale. They will drive a certain distance to refuel until the fuel tank warning light is on. However, sometimes when the fuel warning light lights up and then goes to the gas station, there may be no gas station nearby, causing confusion. In addition, if this happens frequently, the service life of the oil pump of the mixer may be greatly reduced.
以上就是駕駛自上料攪拌車要避免三個錯誤操作問題的相關解答了，您對此如果有什么要分享的想法或者咨詢的問題都可以隨時起來我們網站http://m.zvmc.cn了解。
The above are the answers to three questions about how to avoid wrong operation when driving a self feeding mixer. If you have any ideas or questions to share, you can always come to our website http://m.zvmc.cn Understand.
