自上料攪拌車罐體中的剩料怎么清理
自上料攪拌車在進行工作時，它重要的部件罐體中會有攪拌料的存在，而當工作完畢后，往往會有一些剩料出現，那么這要怎么清理呢？下面混凝土自上料攪拌車廠家為您講解。
When the loading mixer is working, there will be mixing materials in its important parts, the tank, and when the work is completed, there will often be some leftovers, so how to clean up? Next, the manufacturer of concrete self loading mixer will explain it to you.
1、關閉控制室內電源開關，掛上“禁止合閘”警示牌。
1. Turn off the power switch in the control room and hang the warning sign of "No switching on".
2、通知自上料攪拌車死機，與自上料攪拌車鏟斗對準主機下料口接料。
2. Notify the self feeding mixer to stop working, and align the bucket of the self feeding mixer with the main machine discharge port to receive materials.
3、打開倉門，工作人員穿戴好防護用具進入主機內，用鐵锨，風炮等工具清理未攪拌完混凝土。
3. Open the warehouse door, the staff shall wear protective equipment and enter the main machine, and clean the unmixed concrete with shovel, air cannon and other tools.
4、打開自上料攪拌車卸料門，卸掉可以能卸掉的未攪拌完混凝土。
4. Open the discharge door of the self loading mixer truck to unload the unmixed concrete that can be unloaded.
5、罐體內的混凝土清理完后，工作人員檢查主機內葉片是否損壞，直工作人員確認主機內底板，葉片完好，工作人員出主機后，關閉主機倉門。
5. After the concrete in the tank is cleaned, the staff shall check whether the blades in the main engine are damaged until the staff confirm that the inner bottom plate and blades of the main engine are in good condition. After leaving the main engine, the staff shall close the main engine compartment door.
6、在確定通電或者車輛運行正常情況下，工作人員觀察斜皮帶，平皮帶上的石子，砂情況，配合控制室操作員通過裝載機清理掉。
6. When it is confirmed that the power is on or the vehicle is running normally, the staff shall observe the gravel and sand on the inclined belt and flat belt, and cooperate with the operator in the control room to clean them through the loader.
7、清理完廢料，斜皮帶，平皮帶上砂，石子后，進行混凝土正常生產。
7. After the waste materials are cleaned, the inclined belt and the flat belt are sanded, and the stones are removed, the normal production of concrete is carried out.
要是攪拌車在使用的過程中出現了問題，不能夠進行運轉了就要把里面的混凝土及時排除出來，要是混凝土凝結在罐體里面，會對車輛造成腐蝕的。更多注意事項可以來我們網站http://m.zvmc.cn咨詢了解！
If there are problems in the use of the mixer and the mixer cannot operate, the concrete inside must be removed in time. If the concrete condenses in the tank, it will cause corrosion to the vehicle. More precautions can be found on our website http://m.zvmc.cn Ask about it!
